Main Article Content

Abstract

In recent years with the rapid development of the electrical vehicle (EV) of new energy industry, higher requirements are put forward for convenience, safety and reliability of the charging of electric vehicles. Contactless Power Transfer (CPT) systems are applicable for charging electric vehicles (EVs) without any physical interconnection. These systems can be installed on roadways in order to charge the vehicles while driving. The implementation of such on-road charging systems in order to extend the driving range and decrease the EV battery size is investigated in this paper. The percentage of road that should be covered and the power transfer capability of the system are estimated. Some design considerations, such as the distribution and the length of the CPT segments over the road, are explained. Finally, the total power demand for all the passing-by vehicles using the system is calculated and the possibility of powering the EVs directly from renewable energy sources is discussed.

Keywords

Electrical Vehicle, Inductive Coupling, Fuel Consumption, Time of Charging, Wireless Electric Vehicle Charging System (WEVCS)

Article Details

How to Cite
[1]
Nikhil Ambekar, Prathamesh Dongre, RushikeshPawar, and Santosh Prajapati, “ON ROAD CHARGING OF ELECTRIC VEHICLE”, IEJRD - International Multidisciplinary Journal, vol. 5, no. 5, p. 4, Jun. 2020.

References

  1. K.A. Kalwar, M. Aamir, S. Mekhilef, Inductively coupled power transfer (ICPT) for electric vehicle charging – a review, Renew. Sustain. Energy Rev. 47 (2015) 462–475.
  2. H. Barth, M. Jung, M. Braun, B. Schmülling, U. Reker, „„Concept
  3. Evaluation of an Inductive Charging System for Electric Vehicles”, Presented at the 3rd European Conference SmartGrids and E-Mobility, Munchen, Germany, 2011.
  4. M. SangCheol, K. Bong-Chul, C. Shin-Young, A. Chi-Hyung, M. Gun-Woo, Analysis and design of a wireless power transfer system with an intermediate coil for high efficiency, Indust. Electr., IEEE Trans. 61 (2014) 5861– 5870.
  5. S. Lukic, Z. Pantic, Cutting the cord: static and dynamic inductive
  6. wireless charging of electric vehicles, Electr. Magazine, IEEE 1 (2013) 57–64.
  7. M. Fuller, Wireless charging in Californiarange, recharge, and vehicle electrification, Trans. Res. Part C: Emerg. Technol. 67 (2016)
  8. 343–356. [6] J.L. Villa, J. Sallan, J.F.S. Osorio, A. Llombart, High misalignmenttolerant compensation topology For ICPT Systems, IEEE Trans. Indust. Electr. 59 (2012) 945–951.