POWER QUALITY IMPROVEMENT USING UPQC

Authors

  • Prof. P. M. Akotkar Assistant Professor, Department of Electrical Engineering, MSOET,Akola(M.S.), India
  • Prof. P. G. Bhende Associate Professor, Department of Electrical Engineering, MSOET, Akola (M.S.), India

DOI:

https://doi.org/10.17605/OSF.IO/984MH

Keywords:

unified power- quality conditioner (UPQC), pq problems, sensitive load, non linear load

Abstract

Power Quality (PQ) problem mostly refers to Voltage sag, ltage and source current problems and enhance power quality of the system. In this study the performance of new topology of UPQC namely open UPQC is investigated for the mitigation of balanced and unbalanced voltage sag, voltage swell and source current harmonics. The configurations of open UPQC namely Right Shunt Open UPQC (OUPQC-R) is analyzed with various control techniques .In this paper  the capability of the OUPQC-R to enhance the power quality with reference generation and control techniques like Unit Vector Template (UVT) and Instantaneous p-q (PQ) is investigated. Various combinations of these techniques are also analyzed for the configuration of open UPQC. Simulation results carried out by using MATLAB simulink.

Downloads

Download data is not yet available.

References

Rosli Omar and NasrudinAbd Rahim “Mitigation of voltage sag/swell by using DVR” ARPN Journal of Engineering and Applied Sciences, vol. no 4, June 2009.

Bhim Singh and venkateswarlu.P “A simplified control algorithm for three- phase , four wire unified power quality conditioner” Presented at journal of power electronics ,vol no.1, January 2010.

S. N. Gohil, M.V.Makwana, K.T. Kadivar,G.J.Tetar “Three phase unified power quality conditioner(UPQC) for power quality improvement using UVTG Technique” 2013 International conference on renewable energy and sustainable energy [ICRESE’13].

B.Singh, a chandra and k al haddad “review of active filters for power quality improvement” IEEE trans. Industrialelectronics,vol 46, No 5,pp.960-97, oct. 1999.

Vijay Karale and SaurabhJadhao, “Voltage Sag Mitigation Using Dynamic Voltage Restorer” proceeding of 2nd International Conference on Innovations in Electrical and Electronics Engineering (ICIEEE); pp 184- 187, Aug 2015.

V. S. Karale, S. S. Jadhao, M. Tasare, Dr. G. M. Dhole “UVTG Based Dynamic Voltage Restorer for Mitigation of Voltage Sag” , (Submitted for acceptance) In proceeding of International Conference 2015, Computing Communication Control and Automation (ICCUBEA), Pune.

IEEE Std. 1159 – 1995, “Recommended Practice for Monitoring Electric Power Quality”.

P.Boonchiam and N. Mithulananthan, Thammasat “Understanding of Dynamic Voltage Restorers through MATLAB Simulation,” Int. J. Sc. Tech., Vol. 11, No. 3, July-Sept 2006.

R.C.Dugan, M.F.McGranaghan and H.W. Beaty, “Electrical Power Systems Quality”. New York: McGraw-Hill, 1996.

IEEE Recommended Practices and Requirements for Harmonic Control in Electrical Power Systems, IEEE Standard 519-1992, 1992.(Standards and Reports)

Downloads

Published

10-04-2021

How to Cite

[1]
Prof. P. M. Akotkar and Prof. P. G. Bhende, “POWER QUALITY IMPROVEMENT USING UPQC”, IEJRD - International Multidisciplinary Journal, vol. 6, no. ICMRD21, p. 12, Apr. 2021.