DESIGN AND ANALYSIS OF DRUM BRAKE: A REVIEW

Authors

  • Mr. Rupesh Gajanan Rohankar Department of Mechanical Engineering, Pankaj Laddhad Institute of Technology & Management Studies, Buldana (MH), India
  • Dr. Fahim Rahim Sheikh Department of Mechanical Engineering, Pankaj Laddhad Institute of Technology & Management Studies, Buldana (MH), India

Keywords:

Keywords: noise, vibration, drum, AL alloys, grey cast iron, heat exposure, corrosion.

Abstract

The mechanical braking system transforms the vehicle's kinetic energy into heat energy, allowing the vehicle to come to a halt or slow down. To bring the vehicle to a complete halt, a pair of shoes is pressed on the drum in order to provide enough friction. Brake drums are heated and under a lot of thermal stress when they're working. Therefore, materials for brake drums are selected in a manner that allows them to endure high temperatures and pressures. Working in comfort necessitates the development of drum brakes with reduced noise and vibration.

Downloads

Download data is not yet available.

References

Putti Srinivas Rao, D.V.G.Prasad, D.D.S.P.R. Raju, B.R.Phanindra, B.N.Surya, “Development and Analysis of Finned Brake Drum Model for Effective Heat Transfer”, IJSEAS – Volume-2, Issue-9, September 2016.

Arvind P Jinturkar & Prof.Vidyadhar R Bajaj, “Optimization of Hub cum Brake Drum for Weight Reduction”, Imperial Journal of Interdisciplinary Research (IJIR) Vol-2, Issue-8, 2016.

Anup Kumar and R. Sabarish, “Structural and Thermal Analysis of Brake Drum” Middle-East Journal of Scientific Research 20 (8): 1012-1016, 2014.

Bako Sunday, Usman Aminu, Paul O. Yahaya, “Development and Analysis of Finned Brake Drum Model Using Solidworks Simulation”, IJIRSET Vol. 4, Issue 5, May 2015.

Amit Phatak, Prof. Prasad Kulkarni, “Drum Brake Back plate Analysis and Design Modification to Control Squeal Noise”, 2017 IJEDR, Volume 5, Issue 3.

K. Gowthami, K. Balaji, “Designing and Analysis of Brake Drum”, IJRASET Volume 4 Issue IX, September 2016.

Meenakshi Kushal, Suman Sharma, “Optimization of Design of Brake Drum of Two Wheeler through Approach of Reverse Engineering by Using Ansys Software”, IOSR-JMCE Volume 12, Issue 4 (Jul. -Aug. 2015)

Dvsrbm Subramanyam, l. Sravani, “Design and Analysis of Drum Brakes”, International Journal of Research in Advance Engineering Technology, Volume 6, Issue 1 MAY 2017

Downloads

Published

2025-12-24

How to Cite

[1]
Mr. Rupesh Gajanan Rohankar and Dr. Fahim Rahim Sheikh, “DESIGN AND ANALYSIS OF DRUM BRAKE: A REVIEW”, IEJRD - International Multidisciplinary Journal, vol. 10, no. 2, p. 5, Dec. 2025.

Issue

Vol. 10 No. 2 (2025): Volume 10 Issue 2

Section

Articles

License

Copyright (c) 2025 https://creativecommons.org/licenses/by-nc-nd/4.0/

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.