TORQUE WRENCH VERIFICATION SYSTEM

Prof. R. P. Kamdi; Ayushi Gedam; Vaishali Dharmik; Chetana Mohadikar; Ashlesha Purandare

doi:10.17605/OSF.IO/48XGN

Authors

Prof. R. P. Kamdi Dept. of Electronics & Telecommunications Yeshwantrao chavan College of engineering Nagpur,India
Ayushi Gedam Dept. of Electronics & Telecommunications Yeshwantrao chavan College of engineering Nagpur,India
Vaishali Dharmik Dept. of Electronics & Telecommunications Yeshwantrao chavan College of engineering Nagpur,India
Chetana Mohadikar Dept. of Electronics & Telecommunications Yeshwantrao chavan College of engineering Nagpur,India
Ashlesha Purandare Dept. of Electronics & Telecommunications Yeshwantrao chavan College of engineering Nagpur,India

DOI:

https://doi.org/10.17605/OSF.IO/48XGN

Abstract

This project is made to verify whether the nuts and bolts are tightened at output stage. The model has been programmed by embedded system which works as a wireless communication system using some input-output peripherals. The major components used are Nrf24L01, LM1117 (voltage Regulator) & Atmega8. The transmission of signals between the transmitter and receiver is carried out wirelessly through SPI (Serial Peripheral Interface). In this model we are using 4 transmitters and 1 receiver where the nrf are connected at the transmitters and receivers for the communication. A seven segment display is connected at the receiver end to show the count of number of nuts tightened. So basically this project gives us the verification whether the nuts are tightened properly with the help of torque-wrench.